Log monitoring

Market

l   Keyword filtering logs

l   Behavior analysis logs

Traffic monitoring

Market

l   Interface-based traffic trend graph

l   Real-time traffic statistics

l   Display of session number limit

l   Configuration of new session number monitoring

Application

Market

l   Configuration of application types in application/application group mode

Content identification library

Market

l   Configuration of keyword sets

Content template

Market

l   HTTP/FTP protocol keyword filtering

Security defense

Market

l   Uplink packet rate limiting

l   New session limiting

l   Configuration of session number limit policies

Behavior analysis

Market

l   Configuration of behavior analysis policies

l   Configuration of analysis templates

l   Configuring user allowlists, app allowlists, and URL allowlists

UX Improvement Plan

Market

l   Upload of security logs to the cloud

l   Upload of device logs to the cloud

l   Upload of search engine logs to the cloud

IPsec VPN

Market

l   IKEv2

Object

Market

l   Configuration of monitored objects for high availability (HA)

l   Display of monitoring logs

System

Market

l   Display of HA status data

l   Configuration of HA

   Caution

The HA function is for testing only and is not recommended for commercial use.

1093979

When the MTU of the aggregate interface is changed, the MTU of the member interfaces is not changed accordingly.

1088030

The port MIB information obtained through SNMP is inconsistent with the information obtained by running commands on the device.

1078064

On the Object > Content Template > Web App Protection page, when an excluded rule is configured, if the URL contains double quotation marks, the configuration cannot be delivered.

1074729

When a traffic control template is configured on the interface of an expansion card and the expansion card is removed, the YAMS service is suspended after the device is powered off and then powered on again.

1071024

In NAT scenarios, when the IPv6 address configured for the server is the translated source address in the policy, a core dump occurs when a client initiates a ping operation.

1069172

When the single line length of the file imported for custom intelligence is too long, the threat intelligence page does not respond.

1065520

The device upgrade fails in some scenarios.

1061108

When a CSV file that includes information on more than 1,000 users is imported at a time, no error prompt is displayed.

1058090

When log information is forwarded to the syslog server, IP addresses are not translated through NAT.

1054639

When the web page is redirected to the portal authentication page, the page does not respond.

1042295

After the system time is modified on the device, no data is displayed on the traffic analysis page.

1041704

An any-to-any security policy is configured to permit any traffic. However, traffic still hits the default policy.

1039866

The device is deployed at intranet egress in transparent mode, and an attack initiated by an intranet IP address is detected. In this case, the source IP address of the attack session is added to the temporary blocklist, causing disconnection of the entire network.

1031605

Zone information of sub-interfaces is not synchronized between the device web UI and Ruijie Cloud.

1072075

User management policies do not take effect on SSL VPN users.

1128892

The IPsec service is configured, the tunnel interfaces on both ends are bound to PPPoE interfaces, and the DDNS domain names are configured as peer domain names. In this case, when the IP address of a PPPoE interface changes, the tunnel negotiation fails.

1124203

The device restarts unexpectedly due to a power switch failure.

1109962

In the device hardware self-test, if active and standby boot configurations are inconsistent, the test result is abnormal.

1062028

When some PCs at the customer site are authenticated through web-based authentication, the local portal authentication page cannot be loaded, and the authentication fails.

1095935

When the threat intelligence function is enabled on the web UI, the system prompts successful enabling. However, the function is still disabled.